Thank you for choosing EZ-ACCESS Modular Ramps. Please visit www.ezaccess.com or contact us at 1-800-451-1903 for all of your ramping needs.
- 10 - E) INSTALL BASE FEET AND ADJUST HEIGHT: i) Slip the base foot under each support tube (FIG. 11). NOTE: If installing on soft soil it may be n
- 22 - 7) INSTALL LOOPS: A) Install loops using same procedure as handrail with joiner assemblies. 8) INSTALL END CAPS: A) Use end caps when there
- 12 - FIG. 15a FIG. 15b viii) Install four ramp handrail end brackets (these will be used to attach handrails in a later step). a. For 4’, 6’,
- 20 - 5) INSTALL HANDRAILS: A) Install pre-assembled handrail section to side of ramp run (FIG. 22). i) The vertical posts of the handrails each h
- 14 - xiv) Attach support tube bracket to the center saddle bracket using ⅜” nylock nuts and ⅜” washers (FIG. 19). a. To ensure plumb support tubes
- 18 - 2) ANCHOR TOP TRANSITION PLATE: The top transition plate must be anchored to a substantial surface to assure the ramp will not be dislodged.
- 16 - e) If the ramp tread surface is over 36” in height, connect the brace assembly under the ramp as shown in FIG. 22. f) The brace assembly e
- 2 - INSTALLATION GUIDE FOR EZ-ACCESS® MODULAR RAMP SYSTEMS ATTENTION INSTALLER: • 850 lb. weight capacity • Read all instructions, including ‘PERI
- 30 - WARRANTY & REGISTRATION 1. EZ-ACCESS, a division of Homecare Products, Inc., (herein referred to as Manufacturer), warrants that the equi
- 4 - BASIC SYSTEM COMPONENTS: Because each ramp configuration will differ from one another, your system may or may not contain all of these basic sy
- 28 - 14) INSTALL OPTIONAL HURRICANE TIE-DOWN KIT: The installer, based on field conditions, will determine the exact location of the tie downs. As
- 6 - 1) INSTALLING PLATFORMS: If your system does not include a platform, skip to ‘INSTALL RAMP SECTIONS’ of this instruction guide. Generally, we s
- 26 - 12) INSTALL OPTIONAL TOP SUPPORT ASSEMBLY: A) The top support assembly provides supplemental support at the upper end of the ramp. When used,
- 8 - C) CONNECTING TWO PLATFORMS TOGETHER: i) Place the surface of the platform face down, onto cardboard or a lawn so that the platform is not dam
- 24 - 11) INSTALL OPTIONAL HANDRAIL CLOSURE KIT: A) This kit will connect the handrails on a platform to the handrails on one side of the ramp. i)
Commentaires sur ces manuels